To Edit the References of a Feature
1. Select a feature that is the child of references, and perform one of these actions:
◦ In the Model Tree, graphics window, or Reference Viewer, right-click the feature and choose 
Edit References.
Edit References.◦ Click > > 
Edit References.
Edit References.The Edit References dialog box opens and shows the references used by the selected feature.
2. When you are editing the references of a Copy Geometry feature, to show all the references that are available for editing, click References Filters, and then select the Indirect References check box.
3. To replace a reference:
a. Under Original references, select a reference.
b. Click the New reference collector, and select the replacement reference.
4. To replace a body reference with a new body reference:
a. Under Original references, select a body.
b. Make sure the collector under New reference is active.
c. Click > 
New Body. The Body dialog box opens. The name of the new body is displayed, but you can type a new name.
New Body. The Body dialog box opens. The name of the new body is displayed, but you can type a new name.d. Click OK. The new body name appears in the New reference collector.
e. Click OK.
5. To reset a changed reference back to the original reference, select the reference under Original references, and click Reset.
6. To edit the references of other child features of the selected reference:
a. Click 
to expand the Child handling section.
to expand the Child handling section.b. Under Update child features, select the check boxes next to the child features.
7. To roll the model to the most recent feature from which a reference can be selected for the selected reference, click Roll To. This feature is shown next to Roll To.
8. To cycle through the possible positions for the feature that would result from the references:
a. To regenerate the model with the references that were edited so far, click Preview.
b. Under Update child features click 
next to the feature. Each click places the feature at the next possible position.
next to the feature. Each click places the feature at the next possible position. | The button is available for features with internal datum planes if at least one reference of an internal datum plane has been replaced by a new reference, and the feature has been regenerated. |
9. To view features in the Reference Viewer, right-click the feature and choose Reference Viewer.
10. Click OK.