Part Modeling > Creo Flexible Modeling > Offsetting Geometry > To Define Attachment Options for Offset
To Define Attachment Options for Offset
You must be on the Offset Geometry tab to perform this procedure.
1. Click the Attachment tab.
2. Set attachment options:
To reattach the offset geometry to the same solid or quilt where it was originally attached, select the Attach offset geometry check box.
To create round or chamfer geometry in the new location after the geometry selection is offset and attached, and to close the gaps created by offsetting geometry, select the Create round/chamfer geometry check box. Available when Attach offset geometry is selected.
To store the attachment properties to use when you reattach the offset geometry to the model, select the Store attachment properties check box. Available when Attach offset geometry is not selected.
To create surfaces that connect edges to cover the gap left when a surface is offset, click the Create side surfaces collector, and then select chains to use to create the surfaces.
To open the Chain dialog box, click Details.
To extend surfaces of the selected offset geometry and the remaining surface until they intersect, click the Extend and intersect collector, and then select chains to use to create the surfaces.
To open the Chain dialog box, click Details.
To collect edges that act as boundaries for geometry, click the Bounding edges collector, and then select chains to use to create the surfaces.
To open the Chain dialog box, click Details.
To cycle through the available solutions, click Next to find the next solution, or click Previous to find the previous solution when multiple solutions exist. Available when the geometry selected in the Offset surface set collector is from a single body or quilt.
To fail regeneration when the model changes and the same solution type cannot be reconstructed, select the Maintain solution topology check box.