To Run Creo ModelCHECK in Regenerate Mode
Perform the following steps to run Creo ModelCHECK when the model is regenerated:
1. Set the MODE_RUN configuration option to Y in the Regenerate Mode (R) column of the config_init.mc file.
2. Regenerate your Creo Parametric model.
If Creo ModelCHECK runs successfully, a message appears in the Creo Parametric window. If errors or warnings are found, Creo ModelCHECK generates a report in your Web browser.
 |
• You should configure Creo ModelCHECK to run only the most important checks in Regenerate mode (such as buried feature check, children of rounds check) and not the information checks. Creo ModelCHECK then notifies you only when there is a critical mistake.
• In ModelCHECK Regenerate mode, ModelCHECK by default regenerates only the top level assembly. To regenerate all the features of an assembly, set the MC_REGEN_TOP_ASM_ONLY option to N.
|