Manufacturing > Manufacturing > Milling > Trajectory Milling > Example: 2-Axis Trajectory Milling
Example: 2-Axis Trajectory Milling
In this example, you are going to use a chain of edges as the final tool trajectory. You can select the model edges directly as machining references. However, in this example a sketched curve based on these edges is created asynchronously. You can also define such a Curve feature prior to creating the NC sequence. In either case, if geometry of the edges changes at a later time, the Curve feature geometry and the tool trajectory will change accordingly.
You will also set the NC sequence parameters so as to define multiple cutting passes for the NC sequence.
The manufacturing model is shown in the following illustration. You are going to machine the slot on the right.
1. Create a 2-axis Trajectory milling NC sequence.
2. Select a flat end mill with cutter diameter equal to the width of the slot. Set the manufacturing parameters as follows:
3. To define the trajectory curve asynchronously, on the Curve Trajectory tab, click Datum > . The Sketch dialog box opens.
4. Select the bottom of the slot as the sketching plane. The Sketcher tab opens.
5. Click Use and select the three edges shown in yellow in the next figure. Click to exit Sketcher.
6. On the Trajectory Curve tab, click to resume the process of creating the trajectory milling sequence.
7. On the References tab, click Select and select the curve you just created (shown in red in the following figure) as the Machining Reference. Click Done.
8. Select the Offset Cut check box to specify an offset for the cut motion.
9. Click Material To Remove to flip the material removal side from one side of the reference curve or sketch to the other.
The completed toolpath is shown in the following illustration.
10. Click to save the changes.