Measurements Shown for Selections of Three or More Entities

Fundamentals > Fundamentals > Creo Parametric User Interface > The Analysis Tab > Measuring Geometry > Measurements Shown > Measurements Shown for Selections of Three or More Entities

When you select three or more reference entities to measure, the common measurement panel shows the measurements in the next table. The common measurement panel is in addition to the measurement panels for each individual selected entity.

Type of Entity	Measurements Shown
Point • Cable location • Center • Datum point • Facet vertex • Location • Location on a curve, edge, face, or scan curve • Scan point • Vertex
Linear • Linear edge or sketch segment • Facet edge • Datum axis • Coordinate system axis • Axis of a revolved feature • Axis of a cylinder • Intersection that results in a linear entity	Accumulated length
Curve • Edge • Curve • Facet edge • Sketch segment • Cable or pipe centerline	Accumulated length
Radial or diametral curve • 2D arc, fillet, or circle • Radial or diametral edge, curve, or scanned curve • Cable or pipe centerline	Accumulated length
Planar • Datum plane • Planar face, surface, or quilt	Accumulated area, accumulated perimeter
Surface • Face • Surface • Quilt • Cable or pipe surface	Accumulated area, accumulated perimeter
Radial or diametral surface • Face • Surface • Quilt	Accumulated area, accumulated perimeter
Coordinate system
Feature • Curve feature • Surface feature • Faces created from a solid feature	Accumulated area
Part	Accumulated area
Component	Accumulated area
Assembly	Accumulated area
Sphere	Accumulated area
Cone	Accumulated area, accumulated perimeter
Torus	Accumulated area