What's New: Creo Parametric 6.0 > Manufacturing > Dragger Support for Thread Turning in Subtractive Manufacturing
  
Dragger Support for Thread Turning in Subtractive Manufacturing
There are two draggers at the end of the thread turning sequence, to extend the cuts.
User Interface Location: Click Manufacturing > Turn > Thread Turning.
Release: Creo Parametric 6.0.0.0
What is the benefit of this enhancement?
When creating a thread turning sequence, you can visually adjust the start and end points. This gives you control over when to start and finish the thread turning sequence.
Dragger Support for Thread Turning1
Dragger Support for Thread Turning2
Additional Information
Tips:
None.
Limitations:
This enhancement is for the thread turning sequence, only.
Does this replace existing functionality?
No.
Configuration options associated with this functionality:
None.