Creo Tutorials > Creo Flow Analysis Tutorials > Additional Tutorials > Creo Flow Analysis Additional Tutorials > Tutorial 1 - Natural Convection > Natural Convection: Exercise 6—Creating a Monitoring Point
  
Natural Convection: Exercise 6—Creating a Monitoring Point
1. In the Post-processing group, click Monitor Points. Under Results > Monitoring Points, Point 01 is added.
2. Create twenty monitoring points.
3. In Results, under Monitoring Points select a monitoring point.
4. In the Properties panel, Model tab, set values for the Position as listed below:
Points
Positions
Point 01
0, -0.0462, 0
Point 02
0, -0.043, 0
Point 03
0, -0.04, 0
Point 04
0, -0.0367, 0
Point 05
0, -0.0336, 0
Point 06
0, -0.0304, 0
Point 07
0, -0.0272, 0
Point 08
0, -0.0241, 0
Point 09
0, -0.0209, 0
Point 10
0, -0.0178, 0
Point 11
0, 0.0178, 0
Point 12
0, 0.0209, 0
Point 13
0, 0.0241, 0
Point 14
0, 0.0272, 0
Point 15
0, 0.0304, 0
Point 16
0, 0.0336, 0
Point 17
0, 0.0367, 0
Point 18
0, 0.04, 0
Point 19
0, 0.043, 0
Point 20
0, 0.0462, 0
5. In the Functions panel click Turn on/off view properties and select Hide all surfaces from the list.
6. In the Properties panel, Model tab, for Heat set the following:
◦ Output Properties—Yes
◦ Output Derived Variables—Yes