Cyclone Separator with Particle Separation: Exercise 6—Performing the Simulation
Simulation is performed with various options for steady and transient types.
|
|
 Monitoring points must be created before you perform the simulation. |
1. In the Flow Analysis Tree, under Physics select Common.
2. In the Properties panel, Model tab, set values for the options as listed below:
◦ Time Definition — Transient
◦ Simulation Time (Duration) — 1.5
◦ Number of Time Steps — 750
◦ Result Saving Frequency — 100
3. In the
Run group, click
Run to begin the simulation. The default settings are set to
Start from Initial Values and
Steady in the
Run group.
4. Click
XYPlot Panel to view the residuals for the steady simulation.
| The default convergence criterion is 0.1 for steady state simulations. The calculation continues till the simulation time is reached. For better results, run it for more simulation time. |
5. Click OK when the simulation is complete.