This section describes the outputs you can obtain from the Multiphase module. The following types of data are available for output from the Multiphase module:

Primary variables are the fundamental variables for a given set of modules and models. They are required as part of the solution.

Primary variables are automatically activated for selected geometric entities such as boundaries, derived surfaces, interfaces, streamlines, particles, or volumes depending on the modules and models that are selected.

Property variables are the physical properties for the fluids and solids in the domain. They are required as part of the solution.

Physical property output for the Multiphase module is automatically activated for selected volumes and boundaries, except point probes, depending on the models that are selected.

Integrated output are quantities that are integrated over a Boundary, Interface, or Volume.