Configurations Options for Legacy
drawing_setup_file
filename.dtl
Establishes the default drawing setup file option values for any drawing that you create during a Creo Parametric session. If you do not set this option, the default drawing setup file option values are used. Certain parameters in the file are valid only if you have a license for Detail.
default_tolerance_mode
nominal, limits*, plusminus, plusminussym
Sets the default display for dimension tolerances.
• nominal—Displays dimensions without tolerances.
• limits—Displays dimensions as upper and lower limits.
• plusminus—Displays dimensions as nominal with plus-minus tolerances (the positive and negative values are independent).
• plusminussym—Displays dimensions as nominal with a single value for both the positive and the negative tolerance.
|
|
 Groups brought in from other models carry the tolerance display mode that was in effect when they were created. |
pro_crosshatch_dir
<directory name>
Specifies a default directory for your cross-hatch library in which you can save cross-hatching patterns for later retrieval. Its value is the full path name of the default directory. For example, pro_dtl_setup_dir.
pro_surface_finish_dir
<directory name , loadpoint/symbols/surffins
Sets the default directory for your user-defined surface finish symbols. Use the full pathname to avoid problems. For example, /home/users/library/surf_finish.
tol_display
yes, no*
Displays dimensions with or without tolerances.
yes—Makes tolerances visible in the drawing.