To Create, Edit, or Save a Bend Order Sequence
Use the General page of the Sheetmetal Preferences dialog box to create or edit the bend order sequence of a sheet metal body.
1. Follow one of the steps below.
◦ Click > > . The Bend Order dialog box opens.
◦ Select a body in the Model Tree, right-click and select 
Preferences. Select the required body, and click change in the Bend order line.
Preferences. Select the required body, and click change in the Bend order line.The Bend Order dialog box opens.
2. To select a fixed geometry reference that is different from that of the part, click the Fixed geometry collector and choose a different reference.
3. To flip the fixed geometry to the other side of the edge, click Flip.
 | The Flip command is available only when an edge between two nontangent surfaces is selected as a reference. |
4. Click Add Bend and select a bend to add to the sequence.
5. Repeat step 5 until all required bends are added to the sequence.
6. To create a new bend order sequence, click Add Sequence and repeat steps 5 and 6 until all required bends are added to the sequence.
To define a fixed geometry reference different from the part fixed geometry reference, click the Sequence fixed geometry collector and choose a different reference.
7. To edit a bend order sequence, select a sequence from the list and then make any required changes.
8. Click Save to open the Save a Copy dialog box. You can save a copy of the bend order table as an *.html file or a *.txt file.
9. Click OK.