Fundamentals > Creo Parametric User Interface > The Analysis Tab > Measuring Geometry > Measurements Shown > Measurements Shown for Selections of Three or More Entities
Measurements Shown for Selections of Three or More Entities
When you select three or more reference entities to measure, the common measurement panel shows the measurements in the next table. The common measurement panel is in addition to the measurement panels for each individual selected entity.
Type of Entity
Measurements Shown
Point
Cable location
Center
Datum point
Facet vertex
Location
Location on a curve, edge, face, or scan curve
Scan point
Vertex
Linear
Linear edge or sketch segment
Facet edge
Datum axis
Coordinate system axis
Axis of a revolved feature
Axis of a cylinder
Intersection that results in a linear entity
Accumulated length
Curve
Edge
Curve
Facet edge
Sketch segment
Cable or pipe centerline
Accumulated length
Radial or diametral curve
2D arc, fillet, or circle
Radial or diametral edge, curve, or scanned curve
Cable or pipe centerline
Accumulated length
Planar
Datum plane
Planar face, surface, or quilt
Accumulated area, accumulated perimeter
Surface
Face
Surface
Quilt
Cable or pipe surface
Accumulated area, accumulated perimeter
Radial or diametral surface
Face
Surface
Quilt
Accumulated area, accumulated perimeter
Coordinate system
Feature
Curve feature
Surface feature
Faces created from a solid feature
Accumulated area
Part
Accumulated area
Component
Accumulated area
Assembly
Accumulated area
Sphere
Accumulated area
Cone
Accumulated area, accumulated perimeter
Torus
Accumulated area
Was this helpful?