Example: Constructing a Seed and Boundary Surface Set
This example shows how to construct a Seed and Boundary surface set using a Loop surface set as a boundary.
Select a seed surface on the model to establish the surface anchor (seed) surface. Creo Parametric highlights the selected surface as shown below.
Hold down the SHIFT key and move the pointer over the model. Valid surfaces are highlighted and a ToolTip displays the surface name. Select a boundary surface as shown below.
Hold down the SHIFT key and move the pointer over the desired Loop edge of the selected boundary. The Loop surface is highlighted as shown below.
Select the Loop edge that belongs to the selected boundary surface to complete the Loop surface boundary. The Loop surface set is highlighted as shown below.
Release the SHIFT key. The Seed and Boundary surface set is created as shown below.