Cabin Radiation with Convection and Radiation: Exercise 6—Performing the Simulation
Simulation is performed with various options for steady and transient types.
 |
Monitoring points must be created before you perform the simulation.
|
1. In the Flow Analysis Tree, under Physics select Common.
2. In the Properties panel, Model tab, set values for the options as listed below:
◦ Number of Iterations—1000
◦ Time Definition—Steady State Simulation
◦ Result Saving Frequency—1000
3. In the Run group, click 
Run to begin the simulation. The default settings are set to Start from Initial Values and Steady in the Run group.
Run to begin the simulation. The default settings are set to Start from Initial Values and Steady in the Run group.4. Click 
XYPlot Panel to view the residuals for the steady simulation.
XYPlot Panel to view the residuals for the steady simulation.| | The convergence criteria used for this simulation is 1e-6. The simulation is completed when the residuals for all the variables drop by 6 orders or the maximum Number of Iterations is reached. |
5. Click OK when the simulation is complete.