Transversely Isotropic Material—Creo Ansys Simulation

Creo Ansys Simulation > Getting Started with Creo Ansys Simulation > Creating Materials in Creo Ansys Simulation > Transversely Isotropic Material—Creo Ansys Simulation

When you select the transversely isotropic material symmetry on the Structural tab of the Material Definition dialog box, you must specify the following properties of the material:

• Young's Modulus

• Poisson's Ratio

• Shear Modulus

• Coefficient of Thermal Expansion

You can specify the following Material Limits for the transversely isotropic material:

• Tensile Ultimate Stress

• Compressive Ultimate Stress

• Shear Ultimate Stress

• Normalized Tsai-Wu Interaction Term

You can also specify the Failure Criterion for the material..

If you select the Thermal tab, the following properties appear on the Material Definition dialog box:

• Specific Heat Capacity

• Thermal Conductivity

Was this helpful?