Machine
REQ_MACHINE_POWER—Specifies the amount of power necessary for an NC sequence, and can be later used in relations. The default is 0.
* 
The REQ_MACHINE_POWER parameter is inapplicable for Contouring NC sequences.
TRAP_STATUS—Controls the output of the UNLOAD command to the NC sequence CL file. If TRAP_STATUS is set to ON, the UNLOAD command is output at the end of the NC sequence. The default TRAP_STATUS is OFF.
* 
The TRAP_STATUS parameter is inapplicable for Contouring NC sequences.
END_STOP_CONDITION—Specifies the stop command is issued at the end of the CL data output for an NC sequence:
NONE (default)—No command is issued.
OPSTOP—The OPSTOPcommand is issued.
PROGRAM_STOP—The STOP command is issued.
Was this helpful?