To Edit and Set Up a Peck Table
You must set up the peck table before defining a Variable Peck NC step.
1. To edit a Peck table before editing a step, click > > . Alternatively, when editing a Variable Peck drilling step, click
Edit Peck Table on the
Parameters tab.
2. Click one of the following options:
◦ Create—Brings up the Pro/TABLE editor to create a new peck table. An empty table of the proper format will be displayed.
◦ Modify—Brings up the Pro/TABLE editor to modify the peck table values. The current peck depth table will be displayed for editing.
◦ Delete—(Available only at setup time.) Deletes the current peck table. You will be asked to confirm your command to delete the table.
◦ Show—Brings up the Information Window, displaying the values in the peck table.
3. Click Create or Modify. The Pro/TABLE editor window appears. Enter values for Low Diameter, High Diameter, Peck Depth Ratio, and Feed Rate.
4. When you are finished entering values, exit the Pro/TABLE editor and save the changes.