About Cooling Components
Connectors, plugs, and o-rings are used as cooling components to complete the waterline inside a mold base. To define a cooling component, click the EMX Components tab and in the Cooling Component group, select a command described below:
• 
Waterline Designer—Dynamically create cooling circuits.
Waterline Designer—Dynamically create cooling circuits.• 
Cooling Component—Defines a new cooling component.
Cooling Component—Defines a new cooling component.• 
Show waterline—Create a model that contains the full cooling circuits as surface copies.
Show waterline—Create a model that contains the full cooling circuits as surface copies.• 
Assemble a waterline curve—Assembles a waterline curve.
Assemble a waterline curve—Assembles a waterline curve.• —Modifies the diameter of all waterline holes.
• —Modifies the diameter of single waterline holes.
• Delete entire waterline—Deletes all waterline components and holes.
From the Cooling Component dialog box, you can select the Counterbore and Second Diameter check boxes to assign a counterbore or a second diameter to all cooling bores. To define the depth of the bore, in the Define depth by list, select one of the following:
• Enter value—Enter a value.
• Use model thickness—Measure the model thickness and calculate bore depth using a UDF value.
• Use curve length—Measure the selected curve length as a placement reference and calculate bore depth using a UDF value.
 | While the reference groups for all types of components are located in the same assembly, you can place the cooling components in the part mode by setting the configuration option ADD_COOLING_REF_IN_PART to YES. |