Setting Board Parameters
Board-specific parameters, their description, and required parameter values follow:
* 
Bend allowance in a file of imported legacy parameters is calculated using the last value of the factor type specified for the part.
Parameter
Description
Value
BOARD_THICKNESS
Sets the thickness of the board.
Numeric value
BOARD_BEND_ALLOW_FACTOR
Sets the value of Y factor or K factor.
Numeric value
BOARD_BEND_ALLOW_FACTOR_TYPE
Sets Y factor or K factor as the bend allowance factor type.
Y Factor
K Factor
BOARD_UPDATE_BEND_ALLOWANCE_INFO
Makes other bend allowance parameters dependent on the assigned material.
Yes
No
BOARD_PART_BEND_TABLE_NAME
Sets the bend table assigned to calculate developed length of geometry with arcs.
Name
BOARD_BEND_RADIUS
Sets the radius of bends.
Numeric value
BOARD_RADIUS_SIDE
Defines the dimension location scheme of bends.
Inside
Outside
BOARD_BEND_ANGLE
Defines the value of bend angles.
Numeric value
BOARD_BEND_REL_TYPE
Sets the type of bend relief.
No Relief
Obround
Rectangular
Slit
BOARD_BEND_REL_WIDTH
Sets the width of bend relief.
Numeric value
BOARD_BEND_REL_DEPTH_TYPE
Sets the depth type of bend relief.
Blind
Tangent to Bend
Up to Bend
BOARD_BEND_REL_DEPTH
Defines the depth dimension of circular, rectangular, and obround bend relief.
Numeric value
Was this helpful?