Electrical Design > Using Highways > To Add a Highway
To Add a Highway
1. Click Insert > Highway. The CREATE HWAY menu appears.
2. Click Sketch to draw the rail. Left-click to sketch the path. Middle-click to create a break in the rail. Right-click to complete the sketch at the last left click point.
OR
Click Follow Path to draw the highway parallel to the path of the object selected.
OR
Click Use Wire to replace a segment of wire with a highway, through which the wire is routed.
3. When the rail is compete, click Done/Return.
About Highways
To Add Routed Wires to an Existing Highway
To Add a Wire to a Highway While Routing
To Remove Wires from a Highway
To Modify the Highway Entry or Exit Point
To Modify or Delete Highway Names
To Reroute a Highway
To Delete a Highway
To Set Up the Highway Label
Was this helpful?