Material Parameters for Drawings
You can set the following material parameters in the report table in a drawing. When you set the material parameters and update the report table, values displayed in the report table are the same as in the drawing.
PTC_YOUNG_MODULUS
PTC_POISSON_RATIO
PTC_MASS_DENSITY
PTC_THERMAL_EXPANSION_COEF
PTC_TENSILE_ULTIMATE_STRESS
PTC_COMPR_ULTIMATE_STRESS
PTC_SHEAR_ULTIMATE_STRESS
PTC_THERMAL_CONDUCTIVITY
PTC_SPECIFIC_HEAT
PTC_HARDNESS
PTC_CONDITION
PTC_INITIAL_BEND_Y_FACTOR
PTC_BEND_TABLE
PTC_MATERIAL_DESCRIPTION
PTC_MATERIAL_NAME
PTC_REPORTED_MATERIAL
PTC_HARDNESS_TYPE
* 
In Creo Parametric 7.0 and later, you should use the material parameter PTC_REPORTED_MATERIAL to report materials in repeat regions—instead of PTC_MATERIAL_NAME.
The material parameter PTC_REPORTED_MATERIAL reports material for both, single material objects and multi-material objects. In case of multi-material objects, the value reported by PTC_REPORTED_MATERIAL depends on the Detail option ptc_reported_material_in_region.
If you are working on a drawing that is created in Creo Parametric 6.0 or earlier, you must update the drawing with version number 9328114 so that the new material parameters are available.
Was this helpful?