Selecting geometry in Results User Interface
When you select a desired geometry or coordinate system of a model in result window, you can either use Creo+ selection methods or Creo Simulate results window. By default, Creo Simulate uses Creo+ selection methods for selecting geometry and coordinate systems in results.
Creo+ selection methods allows you to select objects directly on your model.
Follow these guidelines when working with Creo+ selection window:
• The model loaded in the Creo+ selection window is a solid representation of the model.
• If your model has shell pairs definitions, post-processor automatically performs the mapping to the compressed geometry.
 |
Creo+ selection window does not allow you to select surfaces or edges of the compressed geometry.
|
• If you select an edge, post-processor assumes them as a curve.
• When you use the Creo+ selection window you can select composite curves.
• If you select a vertex or datum point, post-processor assumes them as a point.
• To select a volume, you should select one or more surfaces of the associated volume. The selection of volume is similar to volume selection in AutoGEM.
• To select the default World Coordinate System, you can click middle mouse button on the selection window.
• When you use Creo+ selection window you can select only those beams that form a chain.
|
|
If you want to select a single beam definition, use Creo Simulate results window. Similarly, use Creo Simulate result window to select a spot weld beam definition.
|
Return to Working with the Results User Interface.