Create profile to mill a hub for DIN 5480
Automatically generate a profile to use with a Mill operation to create the hub for a spline tooth shaft.
To create profile to mill a hub for DIN 5480,
1. Create a workplane on the end face of the hub part. You may find it easier to center the milling profile if you place construction lines, like this:
2. Click Part Library and then, in the Shaft/Hub group, click the arrow next to 
Tooth.
Tooth.3. Click 
Hub Profile DIN 5480. The Hub profile dialog box opens.
Hub Profile DIN 5480. The Hub profile dialog box opens.4. Click Module and select the dimensions for the milling. The remaining values will be automatically populated, but you may change them if desired.
5. Select a Manufacturing method: broaching or shaping.
6. Click Center and select the hub center in the viewport.
7. Select a Direction in the viewport.
8. Click OK 
to complete the operation.
to complete the operation.