Create profile to mill a shaft for DIN 5481
Create a profile to mill a serrated tooth shaft for DIN 5481.
To mill a shaft for DIN 5481,
1. Create a workplane on the end face of the shaft part. You may find it easier to center the milling profile if you place construction lines, like this:
2. Click Part Library and then, in the Shaft/Hub group, click the arrow next to 
Spline sh.
Spline sh.3. Click Shaft profile DIN 5481. The Shaft profile dialog box opens.
Shaft profile DIN 5481. The Shaft profile dialog box opens.4. Click Short symbol and select the dimensions for the milling. The remaining values will be automatically populated, but you may change them if desired.
5. Click Center and select the hub center in the viewport.
6. Select a Direction in the viewport.
7. Click OK 
to complete the operation.
to complete the operation.Limitations
• You must start with a shaft diameter that is appropriate for the milling operation because the shaft is not automatically adjusted for the outer diameter of the teeth.