Creo Elements/Direct Cabling Tutorial 4: Step 1 of 4
Preparation
1. Load CablingTutorial4.pkg.
2. Uncheck the power_box part in the Structure Browser as it is not currently needed.
3. Set the harness active:
◦ Click Cabling and then, in the Harness group, click 
Select. The Set Active Harness dialog box opens.
Select. The Set Active Harness dialog box opens.◦ Double-click Harness_1 in the structure browser.
◦ Click OK 
to complete the operation.
to complete the operation.View the back of the plug and note the two cables have been split into their three-wire representations. You will move these wires to their correct locations. Also note the pre-existing terminals connected to the ground screw and the bottom set of screws:
