Extended modules > Creo Elements/Direct Part Library > Administration > Change a screw connection
  
Change a screw connection
You can change the screw type, hole, and hardware before or after you add the screw connection. These parameters are saved and used the next time you add a connection.
You can change the following parameters:
Screw: Click area A and select a part.
Drill hole: Click area B or E and set the parameters for the drill hole. The Nominal Dia is a diameter available for the screw you select. See Change hole parameters for help with the hole parameters dialog.
Upper hardware: Click area C or D and select a part. This part is placed directly under the screw top and above the drilled hole.
Lower hardware: Click area F or G and select a part. This part is placed on the screw at the bottom of the drilled hole, before the nut.
Nut: Click area H or I and select a part. You may include two nuts in your connection. Nut H is screwed on before nut I.