Creo Elements/Direct Cabling Tutorial 6: Step 4 of 5
Reposition wires in clamps
You need to reposition the wires through the clamps so they do not interfere with other geometry. Use the Re-Arrange command to do this. Delete the 3D representations of your wires before rearranging.
To position wires inside clamps,
1. Click Interface and then, in the Library group, click the arrow next to Fixture.
2. Click Re-Arrange.
3. Click on one of the clamps, and a 2D window will open with 4 circles and a construction geometry cross-hair, like this:
4. Click Rearrange.
5. Click Circle in the dialog box and select one of the 2D circles.
6. The 2D Circle moves with the cursor. Move the circle to the upper-left quadrant of the cross-hairs.
7. Click Circle again and select another circle. Place it in the lower-left quadrant.
8. Arrange the remaining two circles:
9. Click OK to complete the operation.
10. Arrange the cables in the other two clamps.
Zoom in on one of the clamps to see the proper arrangement of wires:
11. Generate a 3D representation of the wires. They should look like this:
Fixture.
Re-Arrange.
to complete the operation.
