Extended modules > Creo Elements/Direct Cabling > Creo Elements/Direct Cabling Tutorials > Creo Elements/Direct Cabling Tutorial 2: Learn to Route Cables > Creo Elements/Direct Cabling Tutorial 2: Step 4 of 6
  
Creo Elements/Direct Cabling Tutorial 2: Step 4 of 6
Change cable tangency
To correctly route the cable through the clamps, you need to change the tangency direction of the spline points you created in the previous steps.
To change a spline point tangency,
1. Click Change Tan in the Modify Spline dialog box.
2. Zoom in on one of the clamps.
3. Click on the spline point. The 3D CoPilot displays in the viewport. Note the direction of the arrow on the CoPilot:
4. Right-click and select New Dir, then hover over one of the circular elements of the clamp. The green arrow should point through the clamp:
5. Right-click and select Accept.
6. Repeat these steps with the other clamp.
7. Click OK to complete the operation.
Your cable no longer intersects or clashes with the sheet metal part: