Extended modules > Creo Elements/Direct Cabling > Manual Routing > Route cables manually by spline
  
Route cables manually by spline
With the Spline command, you can select points in the viewport along which the cabling follows a smooth curve.
To manually route cabling in spline segments,
1. Click Cabling and then, in the Manual Routing group, click Wire.
2. Click Spline Wire. The Create Cable dialog box opens.
3. Select a cable or wire.
4. Click a point in the viewport to start the cable.
Click Dynamic to use the 3D Copilot.
5. Select a method in the Modification by 3D CoPilot section of the dialog. You can switch between these two methods as you route your cable:
Click Adding to add an additional cable segment each time you select a point in the viewport.
Click Moving to move the most recently created cable segment.
6. Continue routing the cable by clicking further points in the viewport or with the 3D Copilot.
7. Click to complete the operation.