Plot Config Menu
To save time when configuring a plot, you can select from the list of predefined plot configurations.
Each predefined configuration contains presettings for the following:
• PLOTTER TYPE
• PLOT DESTINATION
• Delete Old
• Gener Name
 |
If you manually change one of the above settings, the new value will overwrite the predefined value (until you restart Creo Elements/Direct Drafting).
|
To select a predefined plot configuration:
1. Press PLOT.
2. Pick CONFIG.
3. Pick the required configuration in the table of plot configurations.
If you have many entries in the plot configuration table, you can scroll through them with the scroll bar to the right of the table.
Use the scroll bar:
• To scroll to the next page of the plot configuration table: pick the white square at the bottom of the scroll bar.
• To scroll to the previous page of the plot configuration table: pick the white square at the top of the scroll bar.
• To scroll anywhere between the first and last pages: pick anywhere between the top and bottom white squares. Creo Elements/Direct Drafting displays the corresponding part of the plot configuration table.
If you scroll up or down one page, there is always one line overlap between one page and the other.
The scroll bar locator shows your position in the table. For example, if the locator is half-way down the scroll bar then the information you see on the top line (of the table) is halfway through the plot configuration table.