Generate a Variation
The part is now fully constrained. To generate the first variation:
1. Click Parametric and then, in the Create group, click 
Constraints.
Constraints.The Generate Constraints dialog box opens.
2. In the Action area, click Assign.
3. In the Type box, select Dimension.
4. Click Apply.
5. Click the dimension for the radius of the large hole (currently 373.32).
6. Type 250 in the user input line and press ENTER.
7. Click the dimension for the width of the slot (currently 28.48).
8. Type 20.75 in the user input line and press ENTER.
9. Click the dimension for length of the slot (currently 31.41).
10. Type 58 in the user input line and press ENTER.
11. Click 
OK.
OK.12. Click Parametric and then, in the Solve group, click 
Preview.
Preview.The magenta outline shows how the variation will be drawn without changing the part.
Alternatively, you can replace the master part with the new geometry by clicking 
No Keep in the Solve group on the Parametric tab.
No Keep in the Solve group on the Parametric tab.13. Click OK to remove the preview, or 
Undo if you solved with No Keep.
OK to remove the preview, or Undo if you solved with No Keep.Repeat this procedure several times, substituting new values of your choice.
Demopart02 Variation
