Cleaning Up Dimensions You can use the Cleanup Dimensions dialog box to evenly space and increment dimensions from the view outline or selected geometry.

Task 4-8. Cleanup the dimensions in the detail view.

1. Select the detail view, right-click and select Cleanup Dimensions.
1. Disable the Create Snap Lines check box.
2. Select the Cosmetic tab, disable Center Text, and click Apply.
3. The dimensions should appear as shown in the following figure.

Cleaned Dimensions

2. Select the Placement tab and click Baseline.
   • Select the edge shown below in red. 
   • Click Apply > Close.

Cleaning Dimensions

3. The dimensions should appear as shown in the following figure on the left.
   1. Select each dimensions and move approximately as shown on the right.

Moving Dimensions.

4. Click Undo twice to return the dimensions to their previous 'cleaned' locations.
5. Click Save from the main toolbar, and click OK.

This completes the fourth exercise.