Radial Holes The Hole Tool is used to create all hole types.  The type of geometry selected determines which type of hole will be created.  In this task, a cylindrical surface is selected as the Primary Reference.  There are two Secondary References, used to specify the offset plane and the angle plane.

Task 2-3. Create a radial hole on the end of the model for lubrication purposes.

1. Start the Hole Tool from the feature toolbar.
   1. Select the cylindrical surface shown.
   2. Right-click and select Secondary References.
   3. Press CTRL and select datum plane TOP from the model tree and the `D-shaped' surface shown.
2. Click To Next from the depth options flyout in the dashboard.
   1. Type 2 as the diameter value in the dashboard, and press ENTER.
   2. Double-click the angle dimension and enter 45.
   3. Select the Placement tab in the dashboard, and enter 3 for the Axial offset.
3. Click Complete Feature from the dashboard.

	The dynamic preview (yellow shading) is the same for Through All and To Next. You can click Preview Feature to get an accurate preview.