Integration with Other Applications > Windchill Workgroup Manager Documentation > Creo Elements/Direct Modeling
  
Creo Elements/Direct Modeling
Finding Information About Windchill Workgroup Manager for Creo Elements/Direct Modeling
To make it easier to locate information that is specific to your application, Windchill Workgroup Manager documentation is divided between information that is common to all Windchill Workgroup Manager integrations, and information that is specific to each application. This topic describes how Windchill Workgroup Manager documentation is organized.
Common Information for New Users of Windchill Workgroup Manager
If you are new to Windchill Workgroup Manager, you can start with the Introduction to Windchill Workgroup Manager topic that describes the system architecture and the basic concepts. This introduction is common to all applications that are integrated using Windchill Workgroup Manager.
In addition, to learn more about general techniques for managing CAD data and your application data in Windchill, see Managing CAD Data.
Installation Documentation
For instructions on how to install and configure Windchill Workgroup Manager, see the Windchill Workgroup Manager Installation Guide on www.ptc.com. You can search for this guide from the Reference Documents page on https://support.ptc.com/appserver/cs/doc/refdoc.jsp.
What’s New for This Release
For information on what is new for this release in Windchill Workgroup Manager, see PTC Windchill Workgroup Manager section in the Windchill What’s New.
Information Specific to Creo Elements/Direct Modeling
Information specific to Creo Elements/Direct Modeling is covered in the following sections:
Subject
Description
Intended Audience
Describes PDM actions specific to Creo Elements/Direct Modeling.
User
Discusses advanced practices of Windchill Workgroup Manager.
Experienced user, power user
Describes how to configure Creo Elements/Direct Modeling with Windchill, and other aspects of Windchill Workgroup Manager system management.
Administrator
Lists Windchill Workgroup Manager preferences specific to Creo Elements/Direct Modeling.
For general Windchill preferences and how to set them, see Managing Workgroup Manager Preferences.
All