SHA_UNFOLD creates the 2D drawing of a flattened (unfolded) sheet
metal part.
+----------------------------<---------------------------+
| |
-->(SHA_UNFOLD)--+--(:BASE_FACE)-------|face|-----------------------------+
| |
+--(:FLAT_ORIGIN)-----|confirmed pt 3d|------------------+
| |
+--(:FLAT_DIRECTION)--|MEASURE_DIR_3D_SA|----------------+
| |
+--(:OUTPUT_TO_VP)----+--(:OFF)--+-----------------------+
| | | |
| +--(:ON)---+ |
| |
+--(:OUTPUT_TO_ME10)--+--(:OFF)--+-----------------------+
| | | |
| +--(:ON)---+ |
| |
+--(:FILENAME)--------+--(:OFF)-----------------------+--+
| | | |
| +--(:ON)------------------------+ |
| | | |
| +--(:OVERWRITE)---|filename|----+ |
| | | |
| +--|filename|--+----------------+ |
| | | |
| +--(:OVERWRITE)--+ |
| |
+--(:SUMMARY)---------+--(:OFF)-----------------------+--+
| |
+--(:ON)------------------------+
| |
+--(:OVERWRITE)---|filename|----+
| |
+--|filename|--+----------------+
| |
+--(:OVERWRITE)--+
The following options are available to create the 2D drawing for an
unfolded sheet metal part:
-
:BASE_FACE
- specifies the start face on the part.
-
:FLAT_ORIGIN
- specifies the origin of the flat drawing relative to the
sheet metal part.
-
:FLAT_DIRECTION
- specifies the direction of X for the flat drawing.
-
:OUTPUT_TO_VP
- specifies whether to display the flat drawing in a
workplane or not.
-
:OUTPUT_TO_ME10
- specifies whether to write the flat drawing to ME10
or not.
-
:FILENAME
- specifies whether to save the flat drawing in an mi-file
or not, and if yes (:ON) the file name.
-
:SUMMARY
- specifies whether to write a report in a text file or not,
and if yes (:ON) the file name.
Use this action to create the 2D drawing of an unfolded (flattened) sheet metal
part.
SHA_COST_EST terminate action