CoCreate OneSpace Designer - Commands Reference Manual

SET_PART_BASE_DENSITY terminate action

SET_PART_BASE_DENSITY sets the part density of specified parts.

Syntax


--->(SET_PART_BASE_DENSITY)--(:PARTS)--|parts|--+--(:DENS)--|density|------------+---->
                                                |                                |
                                                +--(:COPY)---(:REF_SRC)--|part|--+
                                                |                                |
                                                +--(:CLR)------------------------+

Options

:COPY - copies the density of a reference (source) part to the current base density.
:CLR - clears the base density.

When to use

Use this action to set the base density of a part.

The units for density are derived from the units for length and mass. For example, the default units are millimeter (mm), and gram (g), therefore, the density units are grams per cubic millimeter (g/mm3).

Example

The following parameter sequence modifies the base density of the specified part.

SET_PART_BASE_DENSITY :PARTS "/SDL/pek2" :DENS 27