CoCreate OneSpace Designer - Commands Reference Manual

SET_WP_DEFAULT_MIN_SIZE specifies the minimum size of future workplane borders, by defining lower left and upper right 2D points.

Syntax

---->(SET_WP_DEFAULT_MIN_SIZE)----|pnt 2D|----|pnt 2D|---->

Options

When to use

The border contains:

• The workplane origin
• All real geometry
• At least a part of each infinite construction line
• The temporary local axis, if one is displayed.

As long as the setting is not cleared, the border will not be displayed smaller than the minimum setting, even if the geometry does not fill the area enclosed by the border.

The grid will only be displayed, and caught to, when the grid points or lines are not too close together, in terms of pixels. This means that there will be occasions where you expect to see the grid, but will not. For example:

• If too small a grid spacing is specified.
• If you display the grid, and then zoom away from the workplane, causing the pixel grid spacing to become too small.
• If you display the grid, and then rotate the view or the workplane causing the pixel grid spacing to become too small.

Example

SET_WP_DEFAULT_MIN_SIZE 0,0 52.6,75.3

See also