DA_SETTINGS_CONTOUR_MAP modifies the display characteristics of the contour map in a session.
-->DA_SETTINGS_CONTOUR_MAP---+
|
+----------------------------+
|
+---+--+--(:POSITION)-----+--(:RIGHT)--+--------------------+-->
| | | | |
| | +--(:LEFT)---+ |
| | |
^ +--(:TRANSP)-------+--(:TRANSPARENT)--+--------------+
| | | | |
| | +--(:NOT_TRANSP)---+ |
| | |
| +--(:FRAME)--------+--(:ON)---+----------------------+
| | | | |
| | +--(:OFF)--+ |
| | |
| +--(:FRAME)--------|GET_RGB_COLOR|-------------------+
| |
+-------<-----------<----------<---------<-----------<--+
The following options are available to configure and perform a finite element analysis of a part.
-
:POSITION
- selects the position of the contour map.
-
:RIGHT
- specifies the right side of the display.
-
:LEFT
- specifies the left side of the display.
-
:TRANSP
- selects the type of background.
-
:TRANSPARENT
- selects a transparent background.
-
:NOT_TRANSP
- selects a non-transparent background.
-
:FRAME
- specifies a frame around the contour map.
Use this action when modifying the appearance of the contour map.