[Contents] [Index] [Books]

CoCreate OneSpace Designer - Commands Reference Manual


SET_WP_DEFAULT_GRID_MODE interrupt action

SET_WP_DEFAULT_GRID_MODE sets the grid mode for future workplanes.

Syntax


---->(SET_WP_DEFAULT_GRID_MODE)--+--(:OFF)---+---->
                                 |           |
                                 +--(:DOTS)--+
                                 |           |
                                 +--(:LINE)--+

Options

The following options are available to set your grid mode.

When to use

Use this action before creating one or more workplanes having the same grid mode. This is much easier than changing the grid mode of workplanes after they have been created.

The grid will only be displayed, and caught to, when the grid points or lines are not too close together, in terms of pixels. This means that there will be occasions where you expect to see the grid, but will not. For example:

Example

The following parameter sequence specifies workplanes will be created with a dot grid.

SET_WP_DEFAULT_GRID_MODE :DOTS

See also

SET_WP_DEFAULT_GRID_WIDTH interrupt action SET_WP_DEFAULT_GRID_HEIGHT interrupt action SET_WP_DEFAULT_GRID_COLOR interrupt action SET_WP_DEFAULT_CONSTR_COLOR interrupt action SET_WP_DEFAULT_FRONT_BORDER_COLOR interrupt action
[Contents] [Index] [Books]