Editing Recipes for Using Creo View MCAD Adapters > Introduction to Recipe Editing for Converting CAD Data > Setting Options on the Advanced Tab > Advanced > Miscellaneous tab for Creo Parametric
  
Advanced > Miscellaneous tab for Creo Parametric
Recipe Setting Name
Values
Description
Creo Parametric Command
Drawing Output
HPGL
CGM
DWG
DXF
PDF
Select the desired drawing output format. Default is HPGL.
Creo Parametric Plotter
HPGL plotter name. Valid for HPGL format only.
Drawing Size
As Defined in Creo Parametric
Creates drawing of sheet size as specified in Creo Parametric.
Valid for HPGL format only.
Fixed Below
Creates drawing of sheet size as specified in Drawing X Size and Drawing Y Size below.
Drawing X Size
Width of sheet in inches. Valid for HPGL only.
Drawing Y Size
Height of sheet in inches. Valid for HPGL only.
Conversion Mode
Full
Creates a separate OL file for each instance of a component.
Component
Creates a single OL file for all instances.
Minimum Memory
Controls the amount of memory used by the adapter.
Loads one 3D model file at a time, processes it and then unloads it from memory before processing the next file. All instances shares a single OL file in this mode too.
Angle Dimension Unit
Creo Parametric Config
Degree
Degree-Minute
Degree-Minute-Second
Select the angle dimension unit option to convert.
Default is Creo Parametric Config (Converts as in Creo Parametric.)
Regenerate
Drawings
Regenerate drawings before publishing
Assemblies & Parts
Regenerate assemblies and parts before publishing.
Use Creo Parametric
Macros
Uses Creo Parametric menu commands to erase and close the model.
Mass Properties
Uses Creo Parametric to calculate mass properties for the model.
Model
Geometry
Uses Creo Parametric tessellator to tessellate model.
Planar Annotation
Notes
Uses Creo Parametric tessellator to tessellate planar notes.
This option results in big OL files.
Other Annotations
Uses Creo Parametric tessellator to tessellate other planar annotations.
This option results in big OL files.
Screen Annotation
Notes
Uses Creo Parametric tessellator to tessellate screen notes. This option results in big OL files.
Other Annotations
Uses Creo Parametric tessellator to tessellate other screen annotations.
This option results in big OL files.
Texture Maps
Convert
Publishes models with textures applied. Enabled by default.
* 
Texture applied to faces are converted as Creo Tessellation.
Assembly level textures are not supported.
See Publishing Creo Parametric Texture Maps for more information.
Modify Texture Search Path
Adds the source folder path to the Creo texture search path.
Enable
Restart of Worker in Creation Locale
If proe locale and proe file creation locale are not same, then publish will fail. Enable this option to restart worker automatically in file creation locale.