Working with PTC Installation Assistant
In addition to generating and updating licenses, you can install some of the Creo applications using PTC Installation Assistant. When you start the Assistant, the Welcome screen appears as shown below:
On this screen select a task based on your installation requirements and click Next to proceed.
• Install new software
• Reconfigure existing software
• Setup license
As you perform the various tasks, the processes involved are highlighted on the left pane. Take one of the following actions to end the installation process:
• Click Install and then click Finish to complete the installation and close the Assistant.
• Click Finish to close the Assistant if you are only generating or updating licenses.
• Click [X] at the top-right corner of the Assistant to stop the installation and exit the Assistant at any stage during the installation.
