Creo Simulate > Creo Simulate Results Window > Results for Native Mode > Querying Results > Querying Quantities for Fringe Plots and Linearized Stress Analyses
  
Querying Quantities for Fringe Plots and Linearized Stress Analyses
Creo Simulate provides two commands that let you determine a quantity at a particular location or locations on your model. One command operates for unanimated fringe plots and the other is specific to plots generated from linearized stress analyses. Use these commands on the Home tab for specific queries:
Dynamic Query—Use to find quantity values at any point on your model. You can use this command to pinpoint exact locations or to study a continuously updated quantity as you use your mouse to scan your model.
If you use the command to label a series of locations on your model with their calculated values, you may want to clear these values from the result window after you study them to restore a clean model view.
Linearized Stress—Use to review a report of values linearized between two points you select. The report gives you information on the membrane, bending, peak, and total stresses relative to a coordinate system defined by the two points. You can base the report on a variety of standard measures like von Mises stress or component stress.