Creo Simulate > Modeling Structure and Thermal Problems > Properties > Materials > Extra Reference for Materials > Elastoplastic Materials > Linear Hardening Law
  
Linear Hardening Law
When the stress is below the tensile yield stress, the material behaves elastically. After yielding has occurred, for the linear hardening law the relation between stress and strain can be represented by the graph shown below:
The following equation represents the linear hardening law:
σ = σy + Em εp
where:
σy is the tensile yield stress of the material
εp represents strain
Em is the slope of the stress-strain curve called the tangent modulus. The tangent modulus has the same units as Young's modulus.
Fit the Tangent Modulus to the curve if you use test data to define the material. If you clear the Define By Tests check box, you must enter a constant value for Tangent Modulus.
The value of the tangent modulus is greater than 0 but less than Young’s modulus.
Return to Elastoplastic Materials or To Define an Elastoplastic Material.