Mold Design and Casting > Working with Parting Surfaces > Filling Loops in a Parting Surfaces > To Fill a Loop Using the Fill Loops Command
  
To Fill a Loop Using the Fill Loops Command
1. Click Mold > Parting Surface > Fill Loops or click Cast > Fill Loops. The Fill Loops tab opens.
2. To change the default reference model, click References. The References tab opens. Activate the Reference Model collector and select a reference model from the Model Tree.
3. To specify loops to fill, perform these operations:
a. Click Closures. The Closures tab opens.
b. Activate the Chain collector and select individual loops on the reference model.
c. From the Type list, specify the type of offset for the fill and any required references and offset values.
4. To organize the loops to fill into sets, click *New set in the Closures area and repeat step 4 for each set.
5. Click .