To Manually Set Up the Check Configuration File
1. Open the <filename>.mch file using a text editor. By default, this file is located in <creo-loadpoint>/modchk/text/<language>/config/check.
2. Set a value for the Interactive (I), Batch (B), Regenerate (R),Save (S) and Metrics modes for each check. The values for each check are:
◦ N—Does not perform the check.
◦ Y—Performs the check and lists the results but does not report any problems in the report. Use Y for minor problems or for information-only checks.
◦ E—Performs the check and reports an error if it fails. Errors are reported in the Creo ModelCHECK report. A PDM system can be set to track models with errors or to even reject their submission. Use E for the most serious problems.
◦ W—Does the same as E, except no model parameter is created. Use W for less serious problems.
|
|
 If you see a check that does not apply to your site, turn the check off by setting it to N in all modes. |
3. Save the edited file with the .mch extension.