Peck Table
Variable peck depths are specified in a peck table as a function of tool diameter (CUTTER_DIAM). A peck table contains four parameters:
• Low Diameter—Low end of the tool diameter range. This value must be less than the tool diameter, and cannot be equal to the High Diameter.
• High Diameter—High end of the tool diameter range. This value must be greater than or equal to the tool diameter.
• Peck Depth Ratio—The ratio of the peck depth to the tool diameter.
• Feed Rate—The speed of the tool while drilling.
Peck tables can also be created, modified, or deleted at setup time.
|
|
 When you use a peck table to control the peck depth in a Variable Peck drilling sequence, the PECK_DEPTH parameter will not be included in the list of Cut Depth and Allowances parameters in the Edit Parameters dialog box. |