The CL Command option in the drop-down list of the Customize dialog box allows you to add the specific post-processor words required for correct NC output. These commands will be output to the NC sequence CL file. If you add a tool motion command, the corresponding motion will be also shown in the tool path display on the screen.

When typing values for CL commands, you can input model parameters, preceded by an ampersand (&) sign. If there is a corresponding parameter defined in relations, its value will be used in the CL command. If the parameter is not found, the system will prompt you for the parameter’s type and value, and this parameter will be added to the relations. This way, the CL command can be changed at the top level (through Relations).