To Add a Taper to an Extrude Feature
You can add a taper to an extrude if the section of the feature is a closed loop. You cannot taper an extrude if
Thicken Sketch is selected. The
Extrude tab must be open to perform this procedure.
1. Click the Options tab.
2. Select the Add taper check box.
3. Type a value for the taper angle from -89.9° through 89.9° in the box.
You can enable or disable the
Add taper check box on the
Options tab by setting the
enable_tapered_extrude configuration option. Set the option to
yes to enable the check box, or to
no to disable it.