Simulation > Creo Simulation Live Studies > Example: Modal Simulation
  
Example: Modal Simulation
The following example demonstrates how you can use live simulation to study the natural frequencies of a fan turbine.
To simulate a bolted down part, create a fixed constraint for each of the holes as shown below:
When you run live simulation the following are the deformation results for each mode along with the frequency of each mode:
Mode 1
Frequency: 418.3 Hz
Mode 2
Frequency: 419.2 Hz
Mode 3
Frequency: 419.2 Hz
Mode 4
Frequency: 431.3 Hz
Mode 5
Frequency: 432.6 Hz
Mode 6
Frequency: 432.9 Hz
Note that result values also change depending on the setting of Simulation Quality.
Creo Simulation Live Studies