Predefined Units

Creo Simulate > Additional Information > Units > Predefined Units

Predefined Units

Basic Predefined Units

You can combine predefined units with custom units to create a custom system of units.

The following basic predefined units for length, mass, force, time, temperature and angle are available in Creo Parametric:

Length	Mass	Force	Time	Temperature	Angle
cm ft in micron mil m mm	g kg lbm ounce-m mg slug ton-m tonne	dyne kg-f kip kN lbf N ounce-f ton	day hr micro-sec min msec sec week	C F K R	degree radian

Derived Units

The following additional pre-defined derived units are also available on the Units tab of the Units Manager dialog box.

1 atm = 101,325 Pa

1 bar = 100 kPa

1 BTU = 1055.056 joule

1 cal = 4.1868 joule

1 erg = 1e-7 joule

1 GPa = 1e9 Pa

1 grav = 9.81 m/sec^2

1 g_squared_per_Hz = 1 grav^2 / Hz

1 Hz = 1 / sec

1 kHz = 1000 Hz

1 J = 1 joule

1 joule = 1 N m

1 kcal = 1000 cal

1 kJ = 10e3 J

1 kPa = 1e3 Pa

1 ksi = 1000 psi

1 kW = 1000 W

1 mbar = 0.001 bar

1 mJ = 1e-3 J

1 MPa = 1e6 Pa

1 MW = 1000 kW

1 mW = 0.001 W

1 Pa = 1 N/m^2

1 psi = 1 lbf/in^2

1 km = 1e3 m

1 nm = 1e-9 m

1 mile = 5280 ft

1 nsec = 1e-9 sec

1 RPM = 2*pi rad / min

1 W = 1 joule/sec